starting signal
英 [ˈstɑːtɪŋ ˈsɪɡnəl]
美 [ˈstɑːrtɪŋ ˈsɪɡnəl]
网络 出站信号机; 启动信号; 出发信号; 开始比赛信号; 起跑信号
英英释义
noun
- a signal to begin (as in a race)
- the starting signal was a green light
- the runners awaited the start
双语例句
- Starting healthy new dating relationships also serves as a signal of kids 'overall readiness to launch from the parental nest.
开始健康的新恋爱关系也是孩子基本准备好要离开父母的羽翼的信号。 - Based on leaving the law of intersection traffic flow, the third chapter analyzed the driver starting lost time effect on intersection signal timing parameters.
第三章交叉口车流的驶离规律为基础，分析了驾驶员损失时间对交叉口配时参数的影响。 - Starting from the Rayleigh diffraction integral and using analytic signal complex representation, the propagation equation of ultrashort pulses in free space has been derived in the near-field beyond the paraxial approximation, which is consistent with the paraxial results in previous literatures if the paraxial approximation is made.
从瑞利衍射积分公式出发，利用复解析信号法推导出了等衍射长度超短脉冲高斯光束在自由空间近场非近轴传输方程，在近轴近似条件下与文献已有的近轴结果一致。 - Discussion on the design of the placement of starting signal in electrified railway line
关于电气化铁路正线出站信号机位置设计探讨 - Time shift characteristic and starting determination for signal convolution integral
信号卷积的时移特性和起始时刻的确定 - The Special Disposing for Lighting Circuit of Three Direction Starting Signal
三方向出站点灯电路的特殊处理 - To counter the start and control of the remote controlled system in the power line carrier communication, the design transmission, reception, decoding and resetting of the starting signal are presented.
针对电力线载波通信中远端受控系统的启动及控制这一难题，从启动信号的设计、发送、接收、解码和复位几个方面进行了探讨。 - Traditional analysis method of signal is not efficient to nonstationary signal, such as motor starting current signal.
在电机起动过程中起动电流信号是非平稳信号，用传统的信号分析方法如傅里叶变换无能为力，不能有效地对信号的特性进行分析。 - To sum up, the vibration system of geophysical prospecting car is characterized by its low starting frequency, big inertia mass and random signal.
物探车振动系统的特点归纳起来主要有起扫频率低、簧载质量大并且参有随机信号成分。 - This solution uses programmable ASIC widget to fulfill synchronism between the input signal pulse and MPU clocking signal. It also solves the measuring errors caused by the randomness of starting time and stopping time of the input pulse and strobe signal.
提出利用可编程ASIC器件来实现输入脉冲信号与MPU定时信号同步的实现方法，解决了输入脉冲和给定闸门时间起止时刻随机性引起的测量误差。